電熱恒溫水箱主要用于實驗室中蒸餾,干燥,濃縮,及溫漬化學藥品或生物制品,也可用于恒溫加熱和其它溫度試驗,是生物、遺傳、病毒、水產、環保、醫藥、衛生、化驗室、分析室、教育科研的常備工具。通常由型鋼薄板構成,箱體內有一供放置試品和工作室,工作室內有試品擱板,試品可置于其上進行干燥,工作室內與箱體外殼有相當厚度的保溫層,中以硅棉或珍珠巖作保溫材料。箱門間有一玻璃門或觀察口,以供觀察作室之情況。
箱內裝有鼓風機,工作室內空氣借鼓風機促成機械對流。開啟排氣閥門可使工作室內之空氣得以更換,獲得干燥效果,溫度用儀表進行自動控溫,控溫儀、繼電器及全部電氣控制設備均裝于箱側控制層內,控制層有側門可以卸下,以備檢察或修理線路時用。箱內工作室左壁與保溫層之間有風道,風裝有鼓風風葉及導向板,開啟電機開關可使鼓風機工作。
電熱恒溫水箱保護維修:
1、使用前注意檢查電源電壓是否同本箱額定電壓相符,以免造成不必要的損壞。
2、切勿把本箱放在含酸、含堿的腐蝕性環境中,以免損壞電子部件。
3、需要搬運箱子時,盡量做到輕放,避免劇烈震動后造成內部電氣線路接點松動。
4、注意保護本箱外表漆面,否則不但影響箱體外型的美觀,更重要的是將會(huì )縮短箱體的壽命。
為了讓使用單位能夠維修電熱恒溫水箱一般性的故障,下面介紹一些產生故障時的現象排除方法。
?、俦鞠浣由想娫?,綠色指示燈亮,經過一段時間之后,無升溫現象,此時需檢查箱內底部電熱絲接頭有否松動或燒斷,必要時更換電熱絲。
?、谌缃油娫春?,綠色指示燈不亮,無接觸連接聲,因檢查使用電壓是否同該機型號一致或因經過運輸電線連接處脫落。
?、劢佑泄娘L(fēng)電機的型號,需要將開關至鼓風處末鼓風,先檢查電機接裝螺絲,聯接彈簧是否脫落,如一切正常,尚末鼓風,可以斷電源后用手轉一下電機看是否風葉卡除,反之一切正常,則請電工檢查一下線路。