一、水浴鍋的使用方法
(1)關閉放水閥門,將水浴鍋內注入清水(最好用純水)至適當的深度,一般不超過水浴鍋容量的三分之二。
(2)將電源插頭接在插座上,并在插座的粗孔安裝地線。
(3)開啟電源開關接通電源,調節調溫控制按鈕至設定溫度。
(4)爐絲加熱后溫度的指數上升到控制的溫度時紅燈熄滅,此后紅燈就不斷熄亮,表示恒溫控制器發生作用。
二、注意事項:
1、水浴鍋內水位不可低于電熱管或是無水狀態,會(huì )導致電熱管爆損。
2、使用水浴鍋時,一定要安全可靠接地,水不得溢入到控制箱內。
3、在使用完畢后,要清除水浴鍋的水,并用毛刷把水浴鍋里的粗雜物清理出去,之后再用細軟布將外表面擦干。
4、在每次使用結束后,請馬上清潔儀器。
5、水浴鍋里外面均應干燥無水珠和水氣,設備外觀要整潔光亮,沒有污漬。
6、每月定期進行一次儀器的維護檢查,并隨時填寫好維護記錄。